Mine Caps

Mine Caps are typically used to prevent access to old, abandoned mines. People, especially the young, like to explore their surroundings but may not fully understand the dangers inherent within, and surrounding, a mine.

Why Do Mines Need To Be Capped?

Cave-ins, poor air quality, wet slippery surfaces, etc. are real dangers when entering a mine, but even the surrounding area can be dangerous. Older mines may have been covered with logs or wooden beams with loose rock and soil over the top. These fail over time, creating sinkholes, that may not be visible on the surface, until enough weight collapses it.

Law Requirements

Federal and State laws dictate certain aspects in the capping process, such as allowances for bats to have access. The type of mine, water table, geology, etc. are all considered when choosing which type of cap will be used for a given mine entrance.

Concrete Caps

Concrete continues to be the preferred method for capping vertical shafts. Considerations can be made in the design to allow for an entrance to the mine, a steel door for humans, a slot for bats, a hole for airflow. The slabs thickness can vary from as little as 6 inches to several feet.

Expanding Foam

Expanding foam is quickly replacing concrete for some vertical shafts, typically mines where an entrance for humans is no longer desired. This type of cap is sometimes referred to as a "Plug." Plugs usually have a taper to them, smaller on the bottom and wider on the top, like the cork on a wine bottle. Expanding foam plugs need to be quite thick, usually no less than 6 feet deep. Typically, loose rock and soil is placed over the top.

Steel Plates

1/4 inch or thicker steel-plating is also used, on both horizontal and vertical shafts. These allow for easier customization than concrete, cutting access holes in steel is far easier than building the concrete forms necessary for the same result. This type of cap is used where easy access is a necessity.

From http://en.wikipedia.org/